Wood table lamps – One thing is certain, there is a tremendous sense of satisfaction when a turned table lamp is finished, and it will be turned on for the first time. Route a 1/4 inch groove down the line, leaving an unroasted portion of about 1 cm at each end. Gluing the two sides together such that the grooves are facing each other and clamp the pieces together. Let them clamped for 24 hours.
How to turn wood table lamps, use band saw, cut off the four edges of laminated wood, so you have a symmetrical octagon 15 inches long. Mark the center of each end and fitting this on the lathe. Cut the work piece to the desired shape with chisels, leaving a flat bottom with a 1 inch projection at one end. This will be mounted in a base. Sand down the returned lamp until you have the desired surface.
12 Picture Gallery: How to Turn Wood Table Lamps
After that to turn wood table lamps, attach a circular block of wood on a base plate with screws and the chisel into the desired form for your lamp base. Using a flat bit, drill a hole in the upper part of the base which is the same diameter as one inch extension of the lamp shank. Drill a 1/4 inch hole from the edge of the base so that it meets the hole. Assemble the lamp, gluing light shaft to its base and screw the nipple at the top of the lamp. Thread the cable through the lamp and attach it to the socket. Screw top of the nipple.
This post topic: Lamp Table